Hesswoodwork
Region: US
Monday 15 November 2021 15:18:04 GMT
159295
1558
469
15
Music
Download
Comments
Cincinnati Generalist :
My pref is concave down. 2 points of contact better than 1. Get that side flat then surface the other w planer or table saw.
2021-11-15 18:24:15
122
Allen Ivy :
The people saying plane it first build pine farm house furniture :-)
2021-11-15 16:34:05
56
Bdawg :
bow up
2021-11-15 15:55:54
30
Barry Golash :
Bow up. And take passes from both ends until it gets close to flat. Then run continuous passes. Hope that makes sense
2021-11-15 22:41:56
26
gooddoordad :
judging by the comments....it didn't help cause its 50/50
2021-11-15 16:08:08
23
DRMadeIt :
I personally wouldn’t mess with that piece at its current length. I’d find something using smaller pieces of it. By time you get that milled it’s…
2021-11-15 16:47:01
23
northernzephyr :
You have a lot of fancy equipment but seem to be missing some basics of milling
2021-11-15 16:37:26
15
user9595755185782 :
I’d select a better piece.
2021-11-15 21:54:29
9
Jenn :
So what’s the verdict cuz the poll looks 50/50?.🤔😆
2021-11-20 14:52:51
9
coffeeward :
Now up but be careful not to apply too much downward pressure.
2021-11-15 16:29:32
4
Paul Gouth :
I put bow up
2021-11-15 16:01:33
3
ApostateJusticar :
plane a side first then joint the sides
2021-11-15 16:11:56
3
Danny Viault :
as your saying it, bow up, gap at the bottom
2021-11-15 16:05:57
3
huffraw :
Bow up putting pressure only on the points that make contact.
2021-11-15 18:33:05
3
Robert Eckel841 :
Bow down and hold pressure on the ends
2021-11-15 18:50:06
3
Nathan Lockner :
Bow up.
2021-11-15 16:59:42
2
SoupMueller :
soak it and clamp it flat
2021-11-15 21:50:35
2
user202735319608 :
Up, pass each end a few to get it a little more flat. If possible cut it off at that knot first.
2021-11-15 20:38:01
2
Cagle Acres Woodworking :
gap down
2021-11-15 16:49:54
2
Buckles :
Bow up my friend
2021-11-15 20:00:20
2
Vince :
Frown down.
2021-11-15 17:07:15
2
SAE :
Bow up
2021-11-15 19:40:07
2
To see more videos from user @hesswoodwork, please go to the Tikwm
homepage.
