that's a cold weld. amperage and volts are set too low. didn't clean material prior to welding.
2025-02-21 04:19:03
37
Marty Sheppard :
Never downhill
2025-02-18 20:42:09
7
nev :
what is 2.7 mm in not communism
2025-02-19 05:22:12
13
Billyjoe :
At least 1/8 of a inch
2025-02-19 18:27:38
22
Wild Bill :
Is that positive ground or negative ground?
2025-02-20 05:57:15
5
Peter Singh :
very poor peneastration should be up hill welding
2025-02-21 14:31:29
9
GertjanGsi16v :
maybe get the rust of first
2025-02-18 23:56:07
30
dannypeij :
so for all the comments out there where in the heck can I get a lense that will give me a clear view like that 😳
2025-02-19 00:27:46
7
billyhoe :
that's not a 7018
2025-02-21 17:35:59
1
DJ :
don't like 7018, I like 6011
2025-02-19 23:24:05
3
Donald Brandt :
3/16
2025-03-08 07:32:15
1
Ronnle Nowlin :
1/4"
2025-02-23 09:01:54
2
Vincent Moodley :
Weld quality will be poor because that's what is known as a wash down, low rampage won't give you much penertration.
2025-02-21 20:06:47
2
Keagan morris22 :
Not ganna hold good when not clean with 7018
2025-02-26 03:52:51
1
Chris 🦅 :
I always turn up the right heat to get to the depth that I'm looking for
2025-02-21 05:11:28
1
old man draza :
I wish i had a lens like that one on my hood . Clear as hell.
2025-02-19 02:16:31
4
leeman1987 :
About 1/8 inches at 130 amps
2025-02-19 02:25:17
28
tommysharp82 :
85%
2025-02-21 17:21:31
2
wooisengyuen :
it is not a 7018 rod welding 💯
2025-02-19 00:21:55
2
bear hutch :
100% crank the amps
2025-02-20 02:44:40
11
JClarke84 :
1/16-1/8 pen depending on rod angle, amperage and the temperature of the metal. This looks likes it’s flat weld( just camera angle is odd) and a little cold looking at the bead and how the flux stuck
2025-02-19 12:01:13
3
To see more videos from user @weldwisdom, please go to the Tikwm
homepage.